MagSafe USB-C Node Build

MagSafe USB-C Node Build Download

3D Model Viewer

Reset ViewColor

Use mouse to rotate, scroll to zoom, right-click to pan.

Original Source This is the original source for this file. I modified it to be properly aligned with the bed

Bill of Materials

Item	Link
Heltec V3	https://www.amazon.com/dp/B0DGT68T3R
Flutesan 3 Pieces Magnet Sticker	https://www.amazon.com/dp/B09FZ5Z7S4

Build Steps

1. In order to embed the magnetic ring into the print, it is necessary to print at a .2mm layer height with a .4mm nozzle.

2. Pause the printer at layer number 6 or 7.

3. Make sure the magnet is oriented with the correct side facing down (Test on the phone before hand)

4. Peel the film of magnets and stick the magnets to the inside of the gap in the print.

5. In order for the model to stay compact you have to remove 3 magnets from the ring and the two bottom magnets.

6. Resume the print and it will print over the magnets, which will permanently embed them in the print.

7. When both pieces are printed insert the SMA connector fro outside the print and run the wires inside, with the hexagonal nut fitting in place with the designated area in the print.

8. Install the Heltec board and connect it to the SMA connector,

9. Snap the top in place and your good to go.